MDP - ECONOMICAL METERING PUMP

In stainless steel, enabling the use of all sizes of rotor/stator giving inter- changeability with only one housing and drive unit.

Optimized compression between the rotor and stator using wear-resistant and corrosion-resistant materials. A wide range of alloys, coatings and elastomers are available for each.

With short pitches and a compact design, the conventional geometry produces high pressures.

The seal on both ends is moulded as an integral part of the elastomeric stator. Corrosion of the stator tube is never a problem because the pumped liquid never comes into contact with the metal tube or the bonding adhesive.

With short pitches and a compact design, the conventional geometry produces high pressures.

Stainless steel, or plastic housings for all pump parts. Especially interesting for conveying certain types of chemicals.

Single-acting mechanical seal, independent of direction of rotation, with quench and supply tank (78 cm / 3 to 4 l) to protect the sliding surface against dry running.

Connects the drive shaft to the joint. With gland packing the plug-in shaft is used as a shaft protection sleeve. Upon request, it is available with wear resistant coating.

For easy dismantling of the pump and drive enabling quick replacement of the rotating parts and shaft seals. The plug-in shaft pin secures the shaft connection to the drive and the splash ring protects the bearing from contamination/gland leakage.

Tailor-made selection of base plates. The base plates can be easily combined with different drives from all major manufacturers.

Geared motors, variable speed drives or frequency controlled motors of all major manufacturers, directly flanged to the pump without additional couplings or guards. Covers made of stainless steel are available.

The pressure gauge switches off the pump as soon as a pre-set pressure is exceeded or not reached and protects the pump from increased wear and tear or piping damage.